Sokkia iM-50 Series Operator's Manual page 68

3. Select "S-O data."
4. Press [DISP] to change the distance input mode to <S-O
H>.
• Each time [DISP] is pressed: S-O Coord (coordinates), S-
O HD (horizontal distance), S-O SD (slope distance), S-O
VD (height difference), S-O Ht. (REM measurement).
15.1 Coordinates Setting-out Measurement, 15.3 REM
Setting-out Measurement
• When [LOAD] is pressed, registered coordinates can be
recalled and used. Distance and angle are calculated using
the coordinate value.
"13.1 Entering Instrument Station Data and Azimuth
Angle PROCEDURE Reading in Registered
Coordinate Data"
5. Set the following items.
(1) Sdist/Hdist/Vdist: distance from the instrument station to
the position to be set out.
(2) H ang: included angle between the direction of the
reference and the point to be set out.
• Pressing [COORD] in the second page allows you to enter
the coordinates of the point to be set out.
6. Press [OK] to set the input values.
• The tilt screen is displayed if the instrument is out of level.
Level the instrument.
"7.2 Levelling"
7. Rotate the top of the instrument until "dHA" is 0° and place
the target on the sight line.
8. Press [MEAS] to start distance measurement. The target
and the distance of the point to be set out is displayed (S-
OΔHD).
9. Move the prism to find the point to be set out.
15. SETTING-OUT MEASUREMENT
S-O HD
H d i s t :
H a n g :
LOAD
S-O HD
H
H
LOAD
S-O HD
H
H
S-O HD
HR
S-O HD
dHA
HD
ZA
HA-R
REC
63
0 . 0 0 0 m
OK
DISP
40. 0000
DISP OK
REC OK

MEAS
DISP