Using Internet Explorer (5.X Or Greater Versions Only) - Enterasys ANG-1000 Installation & Service Manual

Aurorean policy server; aurorean policy gateway
Hide thumbs Also See for ANG-1000:
Table of Contents

Advertisement

Chapter 3
Installing Software & Setting Networking Configurables
The procedure to install the Indus River Certificate differs depending on the
browser you are using, Internet Explorer (IE) 5 or higher or Netscape
Communicator 4 or higher. Both browsers let you use the certificate either for
the duration of the session with the ANG or for all subsequent sessions until
the certificate expiration date.
If you are using Internet Explorer, begin installing the certificate below. Skip
to page 47 if you are using the Netscape browser.

Using Internet Explorer (5.x or greater versions only)

To install the Indus River Certificate using Internet Explorer, perform the
following steps:
Aurorean Installation & Service Guide
Configuring General Values of the ANG-3000/7000 with APM
1
Be sure your remote control computer's IP address is still set to an
address in the 192.168.1. x range with a subnet mask of
255.255.255.0. Do not use the 192.168.1.2 IP address.
To change the computer's IP address, use the Network Control Panel
and follow Microsoft's on-line Help instructions. To communicate
with the ANG, this computer must have an address in the same
subnet as the Network Gateway.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ang-3000Ang-7000Aps-3000Aps-7000

Table of Contents