Ang-1000 Front And Rear Leds - Enterasys ANG-1000 Installation & Service Manual

Chapter 4
Basic System Operation
Table 1 APS/ANG-3000/7000 Front Panel LED Meanings (Continued)
This LED... Indicates...
The system is receiving
Green
management messages from
another Aurorean VN system
U2
over an Ethernet link.
Mgmt
Front and rear LEDs on the ANG-1000 are functionally similar to their
counterparts on the APS/ANG-3000/7000 systems with several different
LEDs: Internet, VPN, TX (transmit) and RX (receive) LEDs.
Table 1 describes each LED and indicates what action should be taken for
each LED state (on, off, or blinking)
This LED... Indicates...
The system is powered on or
Green
off. If this LED remains off
Power
even when the system is
connected to a working
power source, the power
supply is no longer functional.
Aurorean Installation & Service Guide
Table 2 ANG-1000 Front and Rear LED Meanings
When
the LED Do the following...
is...
Blinking No action required; the LED blinks when
messages are received.
Off Check the Ethernet ports and LEDs on the
system rear panel to ensure the cables are
securely connected and that the Ethernet
link is active. Check the IP addresses
assigned to each Ethernet port and verify
that any routers or firewalls separating the
systems are configured to pass packets
between the addresses.
When
the LED Do the following...
is...
On No action required.
Off Verify that the power cord is plugged into a
functional wall outlet or UPS and into the
receptacle in the system's rear.
Checking LEDs