Mounting the ANG/APS-3000/7000
Place the Aurorean system near the following:
Aurorean models ANG/APS-3000/7000 are designed for use in computer
rooms and network equipment closets. They can be:
Place the system on a clean and level work surface. Leave several inches of
clearance at the back of the system to allow easy access to ports and cables,
and also provide adequate heat exhaust from the power supply fans.
To mount a Aurorean system in a relay rack, perform the following steps:
r Ethernet wall jack, patch panel, or hub with available ports.
r A grounded wall outlet or uninterruptible power supply (UPS).
r Placed on a tabletop or shelf workspace.
r Mounted in a relay-style rack using the two right-angle midmount
brackets provided.
r Installed in a four-post 19" rack or cabinet using the sliding rails kit.
1
Using a Phillips head screwdriver, securely attach abracket at the
midway point of each side panel of the system with two screws as
shown in Figure 7.
Figure 7 Attaching the Brackets to the system
Mounting & Connecting Systems
Aurorean Installation & Service Guide
Chapter 2