Setting Group Parameters - Enterasys ANG-1000 Installation & Service Manual

Configuring the Remote ANG-3000/7000 with APM
To set the Authentication parameters of the ANG, perform the following
steps. We recommend configuring Group values before User values.

Setting Group Parameters

To set the Group parameters on the ANG, perform the following steps:
1 Click on the Authentication option.
2 Click on the Group tab of the Authentication configuration window.
The Group configuration window appears as shown in Figure 64.
Figure 64 Aurorean Policy Manager Groups WIndow
3 Click Add Group.
The Add Group configuration window appears as shown in
Figure 65.
The default configuration contains two groups: IRAdmin and DEFAULT.
Do not delete IRADMIN or you will not be able to log on with Aurorean
Policy Manager.
Installing Software & Setting Networking Configurables
Aurorean Installation & Service Guide
Chapter 3