Enterasys ANG-1000 Installation & Service Manual page 123

Chapter 3
Installing Software & Setting Networking Configurables
Firewall security is established on the ANG-1000's Trusted interface by
default. But, you may choose to permit unencrypted traffic over External,
Site-to-Site or Trusted connections by disabling Web or Telnet access to them.
Begin Firewall Setup by performing the following steps:
Aurorean Installation & Service Guide
Configuring the ANG-1000 with Aurorean Policy Manager
Enabling any of the following options allows Web or Telnet traffic to run
in the clear over the ANG-1000. You can permit the transmission of
unencrypted traffic but the ANG-1000 will drop packets it receives outside
the tunnel. We recommend that you allow Web and Telnet access on the
LAN connection but disable these permissions on the Internet and VPN
Gateway connections. If you leave all three connections disabled, you will
be unable to configure the ANG-1000 without resetting the system.
1 Click the Firewall Setup menu option.
The Firewall Setup window appears as shown in Figure 79.
Figure 78 Firewall Setup Window
2 Enable the option of your choice and click Apply.