Configuring Authentication Parameters - Enterasys ANG-1000 Installation & Service Manual

Chapter 3
Installing Software & Setting Networking Configurables
Name Server settings are optional. If you do not use DNS or WINS servers on
your network, skip to "Configuring Authentication Parameters" on page 87.
To set the Name Server parameters of the ANG, perform the following steps:
Authentication for ANGs in a site-to-site configuration is employed for
terminating tunnel servers only and for administrator access to the Aurorean
Policy Manager tool. If you are configuring an initiating Network Gateway,
skip to "Configuring Protocols Parameters" on page 92.
Aurorean Installation & Service Guide
1 Click on the Name Servers option.
The Name Servers Configuration window appears as shown in
Figure 63.
Figure 63 Aurorean Policy Manager Name Servers Configuration Window
2 Enter an IP address for the Primary and Secondary DNS servers in
the fields provided.
3 Enter an IP address for the Primary and Secondary WINS servers in
the fields provided.
4 Click Apply Changes.
Configuring the Remote ANG-3000/7000 with APM