Remove The Chassis Sections From The Rail Assemblies - Enterasys ANG-1000 Installation & Service Manual

Mounting the ANG/APS-3000/7000
The rail kit contains the following parts:
To mount a Aurorean Virtual Network system in a 19" rack or cabinet, begin
assembly below.

Remove the Chassis Sections from the Rail Assemblies

Perform the following steps for each rail assembly:
r Two rail assemblies
r Two front brackets (short)
r Two rear brackets (long)
r One package of ten 10/24 x 0.25" panhead Phillips screws, used to
attach the rail chassis sections to the system.
r One package of ten 8/32 x 0.38" flathead countersunk Phillips screws
along with a flat, lock and nut for each screw. They are used to attach
the brackets to the rail rack sections.
1 Slide the rack section out of the slider section as shown in Figure 9.
2 Slide the chassis section out of the slider section until it locks, then
press the lock arm on the chassis section to release it from the slider
section.
3 Pull the chassis section out of the slider section.
4 Repeat steps 1-3 for the second rail assembly.
Rack section Slider section Lock arm
Figure 9 Rail Assembly
Mounting & Connecting Systems
Chassis section
Aurorean Installation & Service Guide
Chapter 2