Controller Status Read - Omron SYSMAC 3G8F5-CLK11-E Operation Manual

Commands and Responses for the Support Board

7-3-5 CONTROLLER STATUS READ

Command Block
Response Block
06 01
Command Response code
code
Operating status
Parameters
The first "V1.00" represents the Support Board version number, and the second
represents the Communications Controller version number.
Node address (response): The Support Board's node address is returned
between 01 and 20 Hex (1 to 32).
Wired/Optical (response)
Unit address (response): The Support Board's Unit address is returned
between 10 and 1F Hex.
Network address: The Support Board's network address is returned between
00 and 7F Hex (0 to 127).
Reads the Controller Link Support Board's controller status.
06 01
Command
code
00 00 00
Status 1 Status 3 Status 5
Status 2 Status 4
Total 6 bytes
Operating status (response): The operating status of the data links is as fol-
lows:
00 (Hex): Data links inactive.
01 (Hex): Data links active.
02 (Hex): Local data links not active. (The data links are active in the net-
work, but the source node is not participating.)
Status 1, Status 4, Status 6 (response): Not used by Controller Link. Always
set to 00 (Hex).
Status 2: This byte contains the following information for Optical Controller Link
Support Boards. (It is always 00 Hex for Wired Controller Link Support Boards.)
Bit
7 6 5
Baud rate setting
0001: 2 Mbps
0010: 1 Mbps
0011: 500 Kbps
Bit
7 6 5 4 3 2 1 0
Not used
0: Wired
1: Optical
00 00
Count 1 Count 8
Status 6
Total 8 bytes
4 3 2 1 0
0 0 0
Power supply status
0: Power not being supplied
1: Power being supplied
Section 7-3
00
Network participa-
tion status
133