Error Codes - Omron SYSMAC 3G8F5-CLK11-E Operation Manual

Status Information and Troubleshooting

10-3-2 Error Codes

Error Contents
code code
0101 Transmission failed; local node
Hex not in Network
0103 Transmission failed; retry count
Hex exceeded
0104 Transmission failed; maximum
Hex number of frames exceeded.
0105 Transmission failed; node
Hex address incorrect
0106 Transmission failed; redundant
Hex node address
0107 Transmission failed; destination
Hex node not in Network
0109 Transmission failed; destination
Hex busy
010A Transmission failed;
Hex communications controller error
010D Transmission failed; destination
Hex address incorrect
010E Transmission failed; routing
Hex tables not registered
010F Transmission failed; routing
Hex table error
0110 Transmission failed; too many
Hex relay points
0111 Transmission failed; command
Hex packet too long
0112 Transmission failed; header
Hex error.
0117 Internal buffer full
Hex
0118 Illegal packet discarded
Hex
174
The following table lists the error codes (in 4-digit hexadecimal) and the contents
of the errors.
Detail code
1st byte 2nd byte
Command block
Bits 0 to 7:
Source node address
Bits 8 to 14: Bits 8 to 14:
Source Network
address
Bit 15:
OFF
Response block Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14: Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Correction
Refer to 10-1 Troubleshooting
Using Indicators and place the
local node into Network.
Using the Controller Link Support
Software or FINS commands, run
echoback test and check
operating environment if errors
occur.
Reduce the number of events per
communications cycle or increase
the maximum number of network
parameter frames.
Refer to Section 3 Software
Installation and check node
address settings to be sure they
are within range and unique.
Correct node addresses so that
they are unique within the same
Network.
Refer to 10-1 Troubleshooting
Using Indicators and place
destination node into Network.
Increase number of retries or
reconfigure system to distribute
load.
Conduct an echoback test and if
the effects of noise are
considerable, reconsider the
operating environment. Restart
the Controller Link Support Board.
If the error occurs again, replace
the Board.
Check routing tables.
Check routing tables and system
configuration. Do not try to access
Networks separated by more than
one other Network.
Be sure to use the correct FINS
command format.
Increase number of retries or
reconfigure system to distribute
load.
Check for nodes sending illegal
packets.
Section 10-3
Recorded
in in
EEPROM
No
No
No
No
No
No
No
Yes
No
No
No
No
No
No
No
Yes