Installation Method; Using The Installer - Omron SYSMAC 3G8F5-CLK11-E Operation Manual

Confirming Normal Startup
3-2

Installation Method

Device Driver
Flow of Installer
Operation

3-2-1 Using the Installer

40
11. Press the N Key.
Note Store the master installation disk carefully.
To enable application of the Controller Link Support Board, carry out the follow-
ing tasks using the software installer.
Copy the necessary files to the hard disk.
Include device drivers (Controller Link BIOS and Controller Link drivers) in
CONFIG.SYS.
The Controller Link Support Board uses the following device drivers.
Controller Link BIOS (CLKBIOS.SYS)
This driver controls Controller Link Support Board I/O according to instructions
from the application. This driver must be included in the CONFIG.SYS to install it
in the computer.
Controller Link Driver (CLKDRV.SYS)
This driver exchanges data with the BIOS when C language library functions are
used or when direct driver calls are made. This driver must be included in the
CONFIG.SYS to install it in the computer. This Controller Link driver must be
come after the Controller Link BIOS described above. Care is necessary when
adding the driver to CONFIG.SYS directly without using the installer.
Install the software using the following procedure. You can choose to only copy
files or to only make changes to CONFIG.SYS.
Specify "Copy" and
"Set" (to install).
Specify "Set"
(to change
settings)
Copy files.
(p 42)
Set CONFIG.SYS.
(p 43)
This section describes how to use the installer using the following example con-
figuration. When the drive configuration is different, replace the drive names with
the ones you are actually using.
Floppy disk drive: Drive A
Hard disk drive: Drive C
Note 1. When the setting of CONFIG.SYS is changed, the previous contents are
saved under file name CONFIG.BAK. If a file called CONFIG.BAK already
exists, the data will be overwritten. To keep the contents of the previous
CONFIG.BAK, change the file name as indicated in the underlined section.
Start the installer
(p 41)
Starting from a
floppy disk
Specify "Copy" (to
replace lost files)
Specify the process.
(p 42)
Set CONFIG.SYS.
(p 43)
End
Section
Starting from a
hard disk
Copy files.
(p 42)
Set CONFIG.SYS.
3-2
(p 43)