Hardware Installation - Enterasys SecureStack B2 B2G124-48P Hardware Installation Manual

Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Read the Release Notes shipped with the switch to check for any exceptions to the supported
features and operation documented in this guide.
This chapter provides the instructions to install the B2G124-48P or B2H124-48P. Unless
otherwise noted, the instructions apply to both switches.
Follow the order of the sections listed below to correctly install the switches.
For information about...
Considerations Prior to Installation
Required Tools
Unpacking the Switch
Installing Optional Mini-GBICs
Installing the Switch on a Flat Surface
Connecting High-Speed Stacking Cables
Configuring Switches in a Stack
Connecting AC and PoE Power
Connecting to Console Port for Local Management
Connecting to the Network
Completing the Installation

Hardware Installation

Important Notice
Refer to page...
3-2
3-2
3-2
3-3
3-5
3-10
3-11
3-14
3-17
3-21
3-30
SecureStack B2 Installation Guide 3-1
3