Guidelines For Flat Surface Installation - Enterasys SecureStack B2 B2G124-48P Hardware Installation Manual

6. To install switches on a flat surface, proceed to "Guidelines for Flat Surface
Installation" on page
the Switch" on page 3‐8.

Guidelines for Flat Surface Installation

Locate the switch within 152 cm (5 ft) of its power source and on a surface as shown in
Figure 3‐6. If an optional redundant power system is going to be installed and connected
to the 14‐pin Redundant Power Supply input connector on the rear of the switch, refer to
the installation guide shipped with the redundant power system.
Caution: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.
Do not connect the switch to the primary power source until instructed to do so later in the
installation process.
Precaución: Para asegurar una buena ventilación y evitar que el sistema se
sobrecaliente, deje un espacio mínimo de 5.1 cm (2 pulgadas) con respecto a los lados y
a la parte posterior del aparato.
No conecte el dipositivo a la fuente primaria hasta que no se le indique.
If you are installing several switches in a stack, proceed to "Connecting High‐Speed
Stacking Cables" on page 3‐10. If the switch is being installed as a standalone switch,
proceed to "Connecting AC and PoE Power" on page 3‐14 for power connection
instructions.
3‐7. For a rackmount installation, proceed to "Rack Mounting
Installing the Switch on a Flat Surface
SecureStack B2 Installation Guide 3-7