Chassis Bottom, Rubber Feet Placement - Enterasys SecureStack A2 A2H123-24 Hardware Installation Manual

Enterasys securestack a2 a2h123-24: install guide

Table of Contents

Installing the Switch on a Flat Surface

Figure 3-1

1 Bottom of chassis as seen when chassis is

resting on its back

2 Locations to install the rubber feet (four locations)

3-4 Hardware Installation

Chassis Bottom, Rubber Feet Placement

Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to

install the rubber feet on each switch before continuing with the installation.

3 Rubber feet with adhesive backing

(four)

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the SecureStack A2 A2H123-24 and is the answer not in the manual?

Securestack a2h123-24