Standards Compatibility
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete SecureStack A2 configuration
management tasks.
For CLI command set information and how to configure the module, refer to the
SecureStack A2 Configuration Guide.
Standards Compatibility
The 10/100BASE‐T ports, 10/100/1000BASE‐T (stack) ports, and 100BASE‐FX ports are
compliant with the following standards and operations:
•
IEEE 802.3
•
IEEE 802.3u
•
IEEE 802.3ab (stack ports)
•
IEEE 802.3ad
•
Full‐Duplex operation
•
IEEE 802.3x Flow Control support for Full‐Duplex mode
LANVIEW Diagnostic LEDs
LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an
easy way to observe the status of individual ports and overall network operations. Refer
to Chapter
1-4 Introduction
4, Troubleshooting for information about using the diagnostic LEDs.