Welcome to the Matrix™ E1 Series (1H582-25 and 1H582-51) Installation Guide. This guide
provides information to help you use this manual, gives a brief summary of each chapter, and lists
technology and user guides that may help you set up and manage the 1H582-xx.
For information about the Command Line Interface (CLI) set of commands used to configure and
manage the 1H582-xx, refer to the Enterasys Networks™ Matrix E1 Series (1G582-xx and
1H582-xx) Configuration Guide.
NOTE: If the information in this document applies to only one of the devices, it will be
referred to by its model number (1H582-25
be referred to as 1H582-xx.
Ethernet expansion module (or simply expansion module) refers to an optional
expansion card that plugs directly into an expansion port slot of the device.
Gigabit Interface Card (GBIC) refers to an optional interface card that plugs into an
Ethernet expansion module that supports GPIMs. The Enterasys Networks GBIC
models are GPIM-01, GPIM-08, and GPIM-09.
Depending on the firmware version used in the 1H582-xx, some features described in this
document may not be supported. Refer to the Release Notes shipped with the device to determine
which features are supported.
WHO SHOULD USE THIS GUIDE
This guide is intended for a network administrator responsible for installing and setting up the
1H582-xx.
ELECTRICAL HAZARD: Only qualified personnel should perform the installation
procedures in this guide.
or
1H582-51
Important Notice
About This Guide
) as appropriate
About This Guide
, otherwise it will
xv