Network Connection Using Fiber Optic Cable - Enterasys Matrix E1 1H582-25 Installation Manual

Connecting to the Network
Figure 3-17 GPIM-09 Launch Mode Conditioning Cable Connection
Â
Launch Mode Conditioning Cable
Multimode Fiber Optic Cables
2. Once the Launch Mode Conditioning cable
optic cable , proceed to
3.8.4

Network Connection Using Fiber Optic Cable

To connect the device using fiber optic cable to the network, perform the following steps:
NOTE: If connecting the device with a GPIM-09 to the network using multimode fiber
optic cables, refer to
1. Remove any protective covers from the fiber optic ports and from the ends of the connectors.
WARNING: The GPIM-08 and GPIM-09 use Class 1 lasers. Do not use optical
instruments to view the laser output. The use of optical instruments to view laser output
increases eye hazard. When viewing the output optical port, power must be removed
from the network adapter.
NOTE: To prevent contamination, leave the protective covers in place when the
connectors or ports are not in use.
CAUTION: Do not touch the ends of the fiber optic strands, and do not let the ends
come in contact with dust, dirt, or other contaminants. Contamination of cable ends
causes problems in data transmissions. If the ends of the fiber optic strands become
contaminated, use a canned duster to blow the surfaces clean. A fiber port cleaning
swab saturated with optical-grade isopropyl alcohol may also be used to clean the ends.
3-26 Hardware Installation
À
Section 3.8.4
Section 3.8.3
Á
Ã
Long Wavelength Gigabit Fiber Optic Device
Ends of the Multimode Fiber Optic Cables and Launch
Mode Conditioning Cables Connections
is connected to the ends of the multimode fiber
to complete the installation to the GPIM-09 device.
before following this procedure.
À
Â