Using Lanview - Enterasys Matrix E1 1H582-25 Installation Manual

Using LANVIEW

4.1 USING LANVIEW
The 1H582-xx uses the Enterasys Networks built-in visual diagnostic and status monitoring
system called LANVIEW. The LANVIEW LEDs
network status for diagnosing network problems.
Figure 4-1 LANVIEW LEDs
PWR LED
Link LED
Table 4-1 describes the LED indications and provides recommended actions as appropriate.
NOTE: The terms flashing, blinking, and solid used in
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
4-2 Troubleshooting
(Figure 4-1) allow you to quickly observe
À Á Â
Receive/Transmit (RX/TX) LED
CPU LED
Table 4-1
Ã
indicate the following: