DIMM Replacement Procedure (4G4282-41)
Note: The following DIMM replacement instructions apply to the 4G4282-41 only. The
DIMM is not considered a field replaceable part on the 4G4202-60. Contact Enterasys
support if this part fails and needs a replacement.
Removing the DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To remove the DIMM from the 4G4282‐41, proceed as follows:
Note: Prior to removing the DIMM from a 4G4282-41, you must remove the Network
Expansion Module (NEM) to gain access to the DIMM memory and connector.
1.
If an optional Network Expansion Module is installed on the main board of the
4G4282‐41, refer to Figure
to step 2.
a.
Remove and save the three screws attaching the Network Expansion Module to
the front panel.
b. Lift the Network Expansion Module straight up and off the two module
connectors on the main PC board.
Memory Locations and Replacement Procedures
B‐1 on page B‐6 and proceed to step 1a. Otherwise proceed
Matrix DFE-Gold Series Modules Hardware Installation Guide B-5