Connecting To A Modem - Enterasys Matrix 7G4280-19 Hardware Installation Manual

Connecting to COM Port for Local Management
5. With a PC connected to a remote modem, you can configure the switch remotely. To
accomplish this, you must configure your PC VT emulation package with the
following parameters:
6. When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix DFE‐Platinum Series Configuration Guide for further
information.
Figure 3-17
1 UTP straight-through
2 RJ45 COM port
3 RJ45-to-DB25 modem adapter
3-28 Installation
Parameter
Mode
Transmit
Bits Parity
Stop Bit

Connecting to a Modem

Å
cable with RJ45 connectors
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Ä Ã Â À
4 Local modem
5 Remote modem
6 PC
Á