Installing Optional Mini-GBICs
Installation
To install a Mini‐GBIC with an MT‐RJ connection, refer to Figure
connection, Figure 3‐2; or for an RJ45 connection, Figure
1.
Hold the Mini‐GBIC with its top side facing up and its 7‐pin edge connector facing the
port slot.
2.
Carefully align the Mini‐GBIC with the port slot.
3.
Push the Mini‐GBIC into the port slot until the Mini‐GBIC "clicks" and locks into
place.
Figure 3-1
1 Mini-GBIC (MGBIC-MT01)
2 Mini-GBIC
3 7-Pin edge connector (insertion side)
3-4 Installation
Note: The following instructions apply whether you are installing a Mini-GBIC in an
network expansion module as shown in the following figures or in the front-panel port slots
1 through 18 of the 7G4280-19.
Mini-GBIC with MT-RJ Connector
top side
,
3‐3, then proceed as follows:
4 Port slot
5 Mini-GBIC
protective dust cover
,
6 Release tab
3‐1; for an LC