Required Tools
Required Tools
Tools needed to install the 7G4280‐19 and options include:
•
Phillips screwdriver
•
Flat blade screwdriver
Unpacking the DFE Module
Unpack the DFE module as follows:
1.
Open the box and remove the packing material protecting the DFE module.
2.
Verify the contents of the carton as listed in Table
Table 3-1 Contents of 7G4280-19 Module Carton
Item
7G4280-19
Installation Guide
Customer Release Notes
3.
Remove the tape seal on the non‐conductive bag to remove the DFE module.
4.
Perform a visual inspection of the DFE module for any signs of physical damage.
Contact Enterasys Networks if there are any signs of damage. Refer to "Getting Help"
on page xviii for details.
Installing Optional Network Expansion Module (NEM)
Refer to your release notes or the Enterasys Networks web site for the latest available
network expansion modules.
Installing a NEM involves
•
removing the coverplate from the DFE module (7G4280‐19),
•
installing the NEM, and
•
installing the Mini‐GBICs.
Refer to the installation instructions shipped with the NEM for details.
3-2 Installation
Note: Install any optional equipment before proceeding to
Installation
Rules" on page 3-7 for an explanation of the rules to install different series
modules in a Matrix E7 chassis.
3‐1.
"Backplane Connections and
Quantity
1
1
1