Overview Of Dfe Module Shutdown Procedure; Offline/Reset Switch - Enterasys 6H308-48 Hardware Installation Manual

Overview of DFE Module Shutdown Procedure

The DFE module
operate under a single IP address as a single, distributed switch system (hardware,
databases, and persistent storage). In this operating environment, the DFE module must
shut down in an orderly fashion to ensure that the other modules in the system and other
devices on the network are notified of the impending change. The device(s) can then make
intelligent decisions and stabilize the network before the change is made; thereby
increasing network availability.
You can shut down a DFE module in an operating system using the OFFLINE/RESET
switch shown in Figure
• Recommended shutdown procedure (page 4‐10)
• Last resort shutdown procedure (not recommended) (page 4‐10)
Figure 4-2

1 OFFLINE/RESET switch

Caution: Do not remove a DFE module from an operating chassis system before reading
the following information and instructions.
Precaución: Antes de retirar los módulos DFE del chasis en funcionamiento, lea las
siguientes instrucciones y la información suministrada.
s
installed in a Matrix N3, N5, or N7 chassis are interdependent and
4‐2. There are two procedures to shut down a DFE module.
OFFLINE/RESET Switch
Overview of DFE Module Shutdown Procedure
À
Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 4-9