Enterasys Matrix 7G4202-72 Hardware Installation Manual page 49

Table 4-2 Troubleshooting Checklist (continued)
Problem Possible Cause
User parameters (IP Position of Mode switch
address, device and (7), Persistent Data Reset,
module name, etc.) was changed sometime
were lost when the before either cycling
module power was power or pressing the
cycled, the front OFFLINE/RESET switch,
panel OFFLINE/ causing the user-entered
RESET switch was parameters to reset to
pressed. factory default settings.
Clear Persistent Data that
was set through Local
Management.
The module was moved
either from slot-to-slot or
from chassis-to-chassis.
Recommended Action
Reenter the lost parameters as necessary. Refer to the
Enterasys Matrix DFE-Platinum Series Configuration
Guide for the instructions to configure the device.
If the problem continues, contact Enterasys Networks
for technical support.
DFE-Platinum Series Hardware Installation Guide 4-5
Troubleshooting Checklist