Installing Module Into Matrix N1, N3, Or N5 Chassis; Installing Module Into N3, N5, Or N1 Chassis (N3 Shown) - Enterasys Matrix 7G4202-72 Hardware Installation Manual

Installing Module into Matrix N1, N3, or N5 Chassis

Installing Module into Matrix N1, N3, or N5 Chassis
A DFE module can be installed in any available chassis slot (1 through 3) in the Matrix N3 chassis,
or slots 1 through 5 in the N5 chassis, or into the single slot of the N1 chassis. All chassis have
horizontal slots for DFE modules. To install the module into the Matrix N3, N5, or N1 chassis,
refer to Figure 3‐3 and proceed as described in "Installing Module into Matrix E7 or Matrix N7
Chassis" on page 3‐5.
Figure 3-3
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel
3-8 Installation
Caution: Failure to observe static safety precautions could cause damage to the DFE module.
Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or
components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la
manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante
entra en contacto con la placa o con los componentes, éstos podrían dañarse.
Caution: When setting the locking levers to the closed position, do not try to force the locking levers
to the point that they touch the face of the front panel. Forcing the locking levers to this point could
damage the module and chassis.
Precaución: Al mover las palancas a la posición de cerrado, tenga cuidado de no llevarlas a un
punto en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo o el
chasis.

Installing Module into N3, N5, or N1 Chassis (N3 shown)

Æ
Ä Å
5 Upper locking tab (shown in closed position)
6 Lower locking tab (shown in closed position)
7 FTM2 backplane connectors
Á
Â
à À