Appendix B: Mode Switch Bank Settings And Optional Installations; Required Tools; Setting The Mode Switches - Enterasys Matrix 7G4202-72 Hardware Installation Manual

This appendix covers the following items:
For information about...

Required Tools

Setting the Mode Switches

Memory Locations and Replacement Procedures
Required Tools
Use the following tools to perform the procedures provided in this appendix:
• Antistatic wrist strap
• Phillips screwdriver
Setting the Mode Switches
Figure B‐1 through Figure
normal operation. These switches are set at the factory to the off position and rarely need to be
changed.
Switch definitions and positions are as follows:
• Switches 1 through 6 – For Enterasys Networks use only.
Caution: An antistatic wrist strap is required to perform the following procedures to minimize ESD
damage to the devices involved.
Precaución: Para minimizar los efectos de las descargas de electricidad estática, deberá utilizar
una pulsera antiestática al realizar los siguiente procedimientos.
Caution: Read the appropriate sections to be fully aware of the consequences when changing
switch settings.
Only qualified personnel should change switch settings.
Precaución: Si desea modificar la configuración del interruptor, lea las secciones correspondientes
para saber cuál será el resultado de hacerlo.
Estas modificaciones a la configuración sólo debe realizarlas personal calificado.
B‐3 show the location of the mode switches and the switch settings for
Mode Switch Bank Settings
and Optional Installations
DFE-Platinum Series Hardware Installation Guide B-1
B
Refer to page...
B-1
B-1
B-2