Dfe Startup Screen Example (Matrix N7 Chassis) - Enterasys Matrix 7G4202-72 Hardware Installation Manual

Completing the Installation
Start the Command Line Interface (CLI) from the module's local console port as follows:
1. Connect a terminal to the local console port as described in "Connecting to COM Port for
Local Management" on page
2. At the login prompt, enter one of the following default user names:
–
–
–
3. Press Enter.
4. The Password prompt displays. Leave this string blank and press Enter. The module
information and Matrix prompt displays as shown in Figure
The DFE module is now ready to be configured. For information about setting the IP address and
configuring Telnet settings for remote access to DFE management, refer to Chapter 3 in the
Enterasys Matrix DFE‐Platinum Series Configuration Guide. The CLI commands enable you to
initially set up and perform more involved management configurations.
The Enterasys Matrix DFE‐Platinum Series Configuration Guide is available online at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described in
"Getting Help" on page xiii.
Figure 3-12
3-18 Installation
ro for Read‐Only access,
rw for Read‐Write access, or
admin for Super User access. (This access level allows Read‐Write access to all modifiable
parameters, including user accounts.)

DFE Startup Screen Example (Matrix N7 Chassis)

login: admin
Password:
M A T R I X N7
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2003
Chassis Serial Number:
Chassis Firmware Revision: xx.xx.xx
Matrix N7(su)->
3‐12. The startup screen, Figure
xxxxxxxxxxxx
Pin Out Descriptions
3‐12, displays.
3‐12.