Table of Contents
Advertisement
Chapter 15
1. Tick the
Enable
checkbox of
2. Keep the HTTPS and HTTP port as default settings (recommended) or enter a value
between 1024 and 65535.
3. Select
Specified Device
4. In the
Only this IP Address
the router.
5. Click SAVE.
Devices using this WAN IP can manage the router by logging in to
IP:port number
(such as http://113.116.60.229:1024).
Tips: The router's WAN IP is usually a dynamic IP. Please refer to
to log in to the router through a domain name.
15 7
System Log
When the router does not work normally, you can save the system log and send it to the
technical support for troubleshooting.
•
To save the system log locally:
1. Visit http://tplinkwifi.net, and log in your TP-Link ID or the password you set for the
router.
2. Go to
Advanced
>
3. Choose the type and level of the system logs as needed.
Remote
Management.
for
Remote
Managers.
field, enter the IP address of the remote device to manage
System
>
System
Log.
http://Router's WAN
Set Up a Dynamic DNS Service Account
Manage the Router
if you want
95
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated