Table of Contents
Advertisement
Chapter 5
5 1
Register a TP-Link ID
If you have skipped the registration during the Quick Setup process, you can:
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to
Advanced
>
3. Click
Sign Up
and follow the instructions to register a TP-Link ID.
4. After activating your TP-Link ID, come back to the TP-Link ID page to log in. The
TP-Link ID used to log in to the router for the first time will be automatically bound as
an Admin.
Note:
• To learn more about the
Admin
• Once you have registered a TP-Link ID on the web management page, you can only register another TP-Link ID via the
Tether APP. Please refer to
• If you want to unbind the admin TP-Link ID from your router, please go to
Device Information
section.
5 2
Change Your TP-Link ID Information
Follow the steps below to change your email address and password of your TP-Link ID
as needed.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID.
2. Go to
Advanced
>
•
To change your email address:
1. Click
behind the Email.
2. Enter the password of your TP-Link ID, then a new email address. And click Save.
TP-Link ID
or click
TP-Link ID
and
User
TP-Link ID, refer to
Manage the Router via the TP-Link Tether App
TP-Link
ID, and focus on the
on the very top of the page.
Manage the User TP-Link
IDs.
to install the app.
Advanced
>
TP-Link
Account Information
TP-Link Cloud Service
ID, an click
Unbind
in the
section.
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated