Table of Contents
Advertisement
Chapter 14
14 1
Change the LAN Settings
The router is preset with a default LAN IP 192.168.0.1, which you can use to log in to
its web management page. The LAN IP address together with the Subnet Mask also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to
Advanced
>
3. Type in a new IP Address appropriate to your needs. And leave the
the default settings.
4. Click SAVE.
Note: If you have set the Port Forwarding, DMZ or DHCP address reservation, and the new LAN IP address is not in the
same subnet with the old one, then you should reconfigure these features.
14 2
Configure to Support IPTV Service
I want to:
Configure IPTV setup to enable Internet/IPTV/Phone service provided by my internet
service provider (ISP).
How can I do that?
1 Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2 Go to
Advanced
3 If your ISP provides the networking service based on IGMP technology, e.g., British
Telecom(BT) and Talk Talk in UK:
1 ) Tick the
IGMP Proxy
either V2 or V3, as required by your ISP.
Network
> LAN.
>
Network
> IPTV/VLAN.
and
IGMP Snooping
Customize Your Network Settings
checkbox, then select the
Subnet Mask
as
IGMP
Version,
79
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated