Table of Contents
Advertisement
Chapter 13
2. Go to
Advanced
>
Note: Before you enable
VPN
static IP address for router's WAN port and synchronize your
3. In the
Client IP Address
leased to the devices by the PPTP VPN server.
4. Set the PPTP connection permission according to your needs.
•
Select
Allow Samba (Network Place) access
your local Samba server.
•
Select
Allow NetBIOS passthrough
Samba server using NetBIOS name.
•
Select
Allow Unencrypted connections
your VPN server.
5. Click SAVE.
6. Configure the PPTP VPN connection account for the remote device. You can create
up to 16 accounts.
1 ) Click
2 ) Enter the
Username
Server.
VPN Server
> PPTP, and tick the
Server, we recommend you configure Dynamic DNS Service (recommended) or assign a
field, enter the range of IP addresses (up to 10) that can be
.
and
Password
Enable
box of PPTP.
System Time
with internet.
to allow your VPN device to access
to allow your VPN device to access your
to allow unencrypted connections to
to authenticate devices to the PPTP VPN
VPN Server
73
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated