Table of Contents
Advertisement
Chapter 14
I want to:
Visit multiple networks and servers at the same time.
For example,
in a small office, my PC can surf the internet through Router A, but I also
want to visit my company's network. Now I have a switch and Router B. I connect the
devices as shown in the following figure so that the physical connection between my
PC and my company's server is established. To surf the internet and visit my company's
network at the same time, I need to configure the static routing.
How can I do that?
1 Change the routers' LAN IP addresses to two different IP addresses on the same
subnet. Disable Router B's DHCP function.
2 Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
Router A.
3 Go to
Advanced
4 Click
Add
and finish the settings according to the following explanations:
Router A
LAN: 192.168.0.1
192.168.0.100
>
Network
> Routing.
Customize Your Network Settings
Router B
WAN: 172.30.30.100
LAN: 192.168.0.2
Switch
PC
Company's server
172.30.30.1
84
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated