Table of Contents
Advertisement
1 ) Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set
for the router.
2 ) Go to
Internet
section.
3 ) Choose an option as needed (enter the MAC address if
Address
is selected), and click SAVE.
Tips:
•
Some ISP will register the MAC address of your computer when you access the internet for the first time
through their Cable modem, if you add a router into your network to share your internet connection, the ISP will
not accept it as the MAC address is changed, so we need to clone your computer's MAC address to the router.
•
The MAC addresses of a computer in wired connection and wireless connection are different.
• Modify the LAN IP address of the router.
Note:
Most TP-Link routers use 192.168.0.1/192.168.1.1 as their default LAN IP address, which may conflict with the IP
range of your existing ADSL modem/router. If so, the router is not able to communicate with your modem and you
can't access the internet. To resolve this problem, we need to change the LAN IP address of the router to avoid
such conflict, for example, 192.168.2.1.
1 ) Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set
for the router.
2 ) Go to
Advanced
3 ) Modify the LAN IP address as the follow picture shows. Here we take 192.168.2.1
as an example.
4 ) Click Save.
• Restart the modem and the router.
or
Advanced
>
Network
>
Network
> LAN.
>
Internet
and focus on the
MAC Clone
Use Custom MAC
108
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated