Table of Contents
Advertisement
Chapter 2
Internet
2
1. Connect the powered-off modem to the router's WAN port with an Ethernet cable.
2. Turn on the modem, and then wait about 2 minutes for it to restart.
3. Connect the power adapter to the router and turn on the router.
4. Verify that the hardware connection is correct by checking the following LEDs.
Power
2.4 GHz
On
On
5. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
the bottom of the router.
2 ) Click the network icon of your computer or go to Wi-Fi Settings of your smart
device, and then select the SSID to join the network.
Computer
Connections are available
Wireless Network Connection
TP-Link_XXXX
TP-Link_XXXX_5G
Connect automatically
1
5 GHz
Internet
On
On
Ethernet cable
Connect
Smart Device
<
Settings
Wi-Fi
Wi-Fi
CHOOSE A NETWORK...
OR
TP-Link_XXXX
TP-Link_XXXX_5G
Other...
Connect the Hardware
3
9
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated