Table of Contents
Advertisement
Chapter 6
•
Channel
- Select an operating channel for the wireless network. It is
recommended to leave the channel to Auto, if you are not experiencing the
intermittent wireless connection issue.
•
Mode
- Select a transmission mode according to your wireless client devices. It
is recommended to just leave it as default.
•
To use the MU-MIMO function:
The MU-MIMO (Multi-User Multiple-Input Multiple-Output) feature enables the router
to simultaneously send data to multiple devices, significantly enhancing the network
efficiency.
1. Go to
Advanced
>
2. Make sure Smart Connect is disabled, and enable MU-MIMO for the 5 GHz band.
Note: MU-MIMO works only on the 5 GHz band and thus is not available when Smart Connect is enabled.
6 2
Schedule Your Wireless Function
The wireless network can be automatically off at a specific time when you do not need
the wireless connection.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to
Advanced
>
3. Enable the
Wireless Schedule
4. Click
Add
to specify a wireless off period during which you need the wireless off
automatically, and click SAVE.
Wireless
>
Wireless
Settings.
Wireless
>
Wireless
Schedule.
feature.
Wireless Settings
30
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Archer AX4400 and is the answer not in the manual?
Questions and answers
I have a tp-link ax 4400 ver.1.6 router. How do you set up wifi 6. When click advance it just sits there with a circle spinning till I close my browser.
If the advanced settings page does not load on the TP-Link Archer AX4400 router, try the following steps:
1. Reboot the Router – Power off the router, wait a few seconds, and turn it back on.
2. Check IP Settings – Ensure your computer is set to obtain an IP address automatically instead of using a static IP.
3. Verify Web Address – Make sure you enter `http://tplinkwifi.net` correctly in the web browser.
4. Reset the Router – If the issue persists, reset the router to factory settings and try accessing the settings again.
If you are setting up WiFi 6, ensure the 2.4 GHz and 5 GHz LEDs are on. If they are off, press and hold the Wi-Fi button on the back of the router for more than 2 seconds until they turn solid on.
This answer is automatically generated