Emergency Operation - Honeywell BC-200 Operation, Installation & Programming Manual

Emergency Operation

1 E
MERGENCY
Isolate Bells
Isolate Warning System
Acknowledging an Alarm
Resetting an Alarm
Isolate an Alarm
BC-200 Manual – P/N DOC-01-013
O
PERATION
Press: EXT BELL ISOLATE

EXT BELL ISOLATE LED will light

The Bells & Buzzer will stop

A subsequent alarm will restart the Buzzer but not the bells

The bell isolate can be toggled by pressing the button a second time
Press: WARN SYS ISOLATE

WARN SYS ISOLATE LED will light

The warning system will stop

A subsequent alarm will restart the Buzzer but not the warning
system

The warning system isolate can by toggled by pressing the button a
second time
Select the Alarm using the PREV , NEXT buttons
Press: ACK to acknowledge

This will individually acknowledge alarms

Once all alarms are acknowledged the alarm LED will go steady
Select the Alarm using the PREV , NEXT buttons
Press: RESET then press ACK to confirm the resetting

This will individually acknowledge and reset alarms

Resets zone in alarm and clears all alarm inputs in the zone

If alarm is still present, the zone(s) will either stay in alarm or re-
alarm again after about 15 seconds
Select the Alarm using the PREV , NEXT buttons
Press: ISOL then press ACK to confirm the isolation

Isolates the point or zone in alarm and clears it's alarm outputs

Isolating a zone automatically acknowledges and isolates all points
in the zone
7