Honeywell BC-200 Operation, Installation & Programming Manual page 97

Appendix
9.3.1.3 E
VENT
Switch 1 of DIP switch SW1 will enable (ON) or disable (OFF) the buzzer for alarms.
Switch 2 of DIP switch SW1 will enable (ON) or disable (OFF) the buzzer for faults.
If the buzzer is enabled, pressing the "MUTE" button will silence the buzzer until a new event is received.
9.3.1.4 D
ISPLAY
The LCD Display is made up of 4 lines of 20 characters each. Events are displayed as:
Date Time
Point Description
Point / Zone Number
Comms Indicator
In the above example, a fault occurred on the 10
occurred in the East Wing on point number 1.1.Z3. There are 0 alarms, 1 fault, and 0 isolates on the system.
10 SEPT 12:37 1/2
WEST WING
1.1.Z7 ALARM
*A=2 F=2 I=0
9.3.1.5 S
PECIAL
ALL SYSTEMS NORMAL
COMMS FAILURE *
CPU NOT RESPONDING
BC-200 Manual – P/N DOC-01-013
S
OUNDER
10 SEPT 12:34
EAST WING
1.2.Z6
*A=0 F=1
Total Alarms
In this example, an alarm occurred on the 10
two alarms and occurred in the West Wing on point number 1.1.Z7. There are 2 alarms,
2 faults, and 0 isolates on the system.
M
ESSAGES
The system is 100% normal with no alarms, faults, or
isolates.
This messages flashes and appears when the LCD80 has
not been polled by the CPU in over 10 seconds
The LCD80 is being polled by the CPU, but the CPU has not
responded to an LCD80 request in over 20 seconds
Event No / Total Number of Events
1/1
Point Status
FAULT
I=0
Total Isolates
Total Faults
th
September at 12:34pm. It is the first of only one fault and
th
of September at 12:37pm. It is the first of
97