Honeywell BC-200 Operation, Installation & Programming Manual page 52

Panel Operation
7.3.4.3 S
ERVICE
This screen allows the operator to isolate or de-isolate an output point.
ISOLATE / DE-ISOLATE A POINT
DAY MODE
20 JULY 2002 14:44:37
SELECT A POINT TO ISOLATE:
00.004.01 BELL OUTPUT
00.004.O2 WARNING SYSTEM
00.004.O3 A/C TRIP
00.004.O4 (LOCAL RELAY)
00.004.O5 GENERAL ALARM OUTPUT
00.004.O6 COMMON FAULT OUTPUT
00.004.O7 COMMON ISOLATE OUTPUT
00.004.08 (LOCAL RELAY)
01.001.O1 LEVEL 1 OUTPUT
01.001.O2 LEVEL 2 OUTPUT
01.001.O3 LEVEL 3 OUTPUT
01.001.O4 (AZM8)
01.002.O1 (AZM8)
01.002.O2 (AZM8)
01.002.O3 (AZM8)
01.002.O4 (AZM8)
UP DOWN
7.3.4.4 S
ERVICE
This screen allows the operator to isolate or de-isolate an input point.
ISOLATE / DE-ISOLATE A POINT
DAY MODE
20 JULY 2002 14:44:37
SELECT A POINT TO ISOLATE:
01.010.I1 SPF 1 RUNNING
01.010.I2 SPF 1 FAULT
01.010.I3 (FANC)
01.101.I1 BUTTON 1 ON 16AT
01.101.I2 BUTTON 2 ON 16AT
01.101.I3 BUTTON 3 ON 16AT
01.101.I4 BUTTON 4 ON 16AT
01.101.I5 BUTTON 5 ON 16AT
01.101.I6 BUTTON 6 ON 16AT
01.101.I7 BUTTON 7 ON 16AT
01.101.I8 BUTTON 8 ON 16AT
01.101.I9 (ACM16AT)
01.101.I10 (ACM16AT)
01.101.I11 (ACM16AT)
01.101.I12 (ACM16AT)
01.101.I13 (ACM16AT)
01.101.I14 (ACM16AT)
01.101.I15 (ACM16AT)
01.101.I16 (ACM16AT)
UP DOWN
BC-200 Manual – P/N DOC-01-013
M – I
ENU SOLATE
A = 0
F = 0
I = 1
N = 0
I
ACKN ISOL
DEISOL
M – I
ENU SOLATE
A = 0
F = 0
I = 1
N = 1
x
I
ACKN DEISOL
ISOL
– D L
OUT IST
Actions:
Use the UP and DOWN buttons to select the
appropriate point and then press the ISOL button
to isolate or the DEISOL button to de-isolate the
point. If the point is isolated, an "I" will appear on
the right hand side of the screen next to the point.
– D L
IN IST
Actions:
Use the UP and DOWN buttons to select the
appropriate point and then press the ISOL button
to isolate or the DEISOL button to de-isolate the
point. If the point is isolated, an "I" will appear on
the right hand side of the screen next to the point.
52