Placing Into Operation Checklist; Pre Power -U P Checks; Power U P Checklist - Honeywell BC-200 Operation, Installation & Programming Manual

Placing Into Operation
2 P I
LACING
2.1 P P
RE OWER

System general appearance good

Cabinet colour and condition good

Cabinet keyed 003

All circuit boards firmly fastened

Manual call point fitted & functional

Viewing window clear and firmly secured

Cable entries adequately sealed

240 VAC cabling correctly terminated

All earthing secured

Power supply securely mounted

Power supply correctly wired

All ribbon cables firmly secured

All other components securely inserted

LCM boards correctly addressed and all analogue loops have been tested as per section 9.6.4.2

BC-200 manufacturing label affixed
You are now ready to power up the BC-200 Fire Indicator Panel.
Note: When re-booting the panel, power off for at least 10 seconds or LCM modules might not operate correctly.
2.2 P U
OWER

Ensure batteries are disconnected.

Turn mains switch To "ON"

After a few seconds, some power-up information should be displayed on the LCD screen, which will then
clear and display the alarm screen.

Under normal conditions the "NO ALARMS" message will be displayed.

The indicator LED's on the rear of the CPU board will flash on and off.

The MAINS ON and FIRE FIGHTER lamps will be lit.

Connect the batteries.
Caution!!
Incorrect polarity of batteries may cause permanent and serious damage to the system.

Check for system faults by pressing, "Service Menu", "List", "Faults". If there are any faults, either rectify
or note in fault log on following page
Y
OU ARE NOW READY TO COMMENCE USING THE
BC-200 Manual – P/N DOC-01-013
O
NTO PERATION
-U C
P HECKS
C
P HECKLIST
BC-200
C
HECKLIST
.
FIRE PANEL
8