Appendix
Actual Fault
Beam Blocked
Alignment Mode
Device Disabled
Zone Disabled
Initialisation Mode
Incorrect Position
Over Range
Under Range
Device Inhibit
No Threshold
Programmed
Trouble 1
Trouble 2
Comms Loss
Command Failed
Thermistor Fault
IR Fault
IR Light Saturation
CO 6 Month Of Life
CO Life Expired
CO Fault
BC-200 Manual – P/N DOC-01-013
Code
Possible causes
Displayed
FAULT (F024)
Beam Detector Fault - Something has come between the detector's
beam and its reflector.
FAULT (F025)
Beam Detector Fault - A beam detector is in configuration mode.
FAULT (F026)
Not used on BC-200.
FAULT (F027)
Not used on BC-200.
FAULT (F028)
Beam Detector Fault - A beam detector is running through its
initialization sequence.
FAULT (F029)
Beam Detector Fault -
FAULT (F030)
Not used on BC-200 - FMM-4-20.
FAULT (F031)
Not used on BC-200 - FMM-4-20.
FAULT (F032)
Not used on BC-200 - FMM-4-20.
FAULT (F033)
Not used on BC-200 - FMM-4-20.
FAULT (F034)
Not used on BC-200 - FMM-4-20.
FAULT (F035)
Not used on BC-200 - FMM-4-20.
FAULT (F036)
Not used on BC-200 - FMM-4-20.
FAULT (F037)
Not used on BC-200 - FMM-4-20.
FAULT (F038)
Not used on BC-200 - FlashScan mode only.
FAULT (F039)
Not used on BC-200 - FlashScan mode only.
FAULT (F040)
The infrared sensor on a FSC-851 detector is saturated.
FAULT (F041)
The CO (carbon monoxide) detection element on a TC840C1000
detector has six months left to expiration.
FAULT (F042)
The CO (carbon monoxide) detection element on a TC840C1000
detector has expired.
FAULT (F043)
Not used on BC-200 - FlashScan mode only.
109