Cpu - Honeywell BC-200 Operation, Installation & Programming Manual

Appendix
9 9 . . 6 6 . . 2 2 C C P P U U
LCD Backlight
9.6.2.1 U
PLOAD
Port Information
Mode RS232
Baud Rate 115200
Data Bits 8
Stop Bits 1
Parity None
Handshaking None
Cable Specification BC-200 End (CONN2)
DB9 Male
9.6.2.2 P
RINTER
Caution: The PS/2 keyboard and serial printer must not be connected at the same time or printing errors will result.
The serial printer (where fitted) must be disconnected whilst the keyboard is plugged in.
Port Information
Mode RS232
Baud Rate 9600
Data Bits 8
Stop Bits 1
Parity Odd
Handshaking Hardware
Cable Specification BC-200 End (CONN1)
DB9 Male
DPU414 thermal printer with 9 pin connector
Note: If using a
printer (1 to 1). Refer to printer manual for detailed connection information.
BC-200 Manual – P/N DOC-01-013
Script Running LEDs
Plug
Panel LED
connector
Panel button
connector
LCD contrast adjust
IBM PS/2 Keyboard Connector
Keyboard Enable
Jumper
/D P
OWNLOAD
2 (RX)
3 (TX)
5 (REF)
8 (CTS)
P S
ORT ETTINGS
3 (TX)
5 (REF)
8 (CTS)
Restart Switch Test points
PS/2
Keyboard
Connector
Serial Printer
Port
S
ORT ETTINGS
Connector Information
Type
Location
TX
RX
GND
Connector Information
Type
Location
RX
GND
CTS
, connect pins 3, 5, 8 on BC-200 to pins 3, 5, 8 on the
Data Connector to
Termination Board
Option Switch
Serial I/O connector
to Termination
Board
5V Power
Connector
Upload/Download
Serial Port to PC
DB9 Female
CPU Conn 2
Pin 3
Pin 2
Pin 5
Laptop End
DB9
Female
2 (RX)
3 (TX)
5 (REF)
7 (RTS)
DB9 Female
CPU Conn 1
Pin 2
Pin 5
Pin 8
Printer End (25 or 9 pin)
DB25 DB9 Male
Male
3 (RX) 2 (RX)
7 (REF) 5 (REF)
4 (RTS) 7 (RTS)
114