Honeywell BC-200 Operation, Installation & Programming Manual page 35

Panel Operation
7.3.3.7.1.1 Service Menu – List – List – Analog – Detectors – Status
This screen will show a reading of the selected Analog addressable detector updated every 3 seconds, 255 times.
The detector's current configuration is displayed together with "live readings" as shown below.
Heat Detector
ANALOG MENU – STATUS
DAY MODE
20 JULY 2002 14:44:37
L1D2 (Z001) > APARTMENT 1 BATHROOM
Poll Mode > FlashScan Mode
Programmed As > HEAT
Actual Device > HEAT
Device State > NORMAL
Device Status > NORMAL
LED Status > Polling
Detector Values:
Alarm = 0%
Temperature = 24 C
Device Scanned 255 Times .
PREV
NEXT
Note: ":Zxxx" is displayed after the descriptor, xxx is the zone number mapped to the detector. A zone number of 0
is an indication that the detector is not mapped to a zone.
Actions:

Press the PREV buttons to move to the previous installed point.

Press the NEXT buttons to move to the next installed point.

Press the TEST button to enter test menu for the detector.

Press the RESET button to re-initialise the detector.

Press MENU to return to the Analog Menu screen.
Explanations of terms:
Variable Range
Poll Mode CLIP
Programmed As 8 Types
Actual Device 8 Types
Device State Normal/Active/Alarm
Device Status 23 fault types
LED Status 4 Types
Alarm %
Pre-alarm %
Peak Alarm Value % or
Drift Compensation %
Sensitivities 1-9
BC-200 Manual – P/N DOC-01-013
A = 0
F = 0
I = 0
N = 0
Peak Temperature = 30 C
Day Alm Sensitivity= 5
Night Alarm Sens = 1
TEST RESET Menu
Description
Shows the current polling protocol being used. CLIP = 1 detector
at a time. Polling mode is auto sensed at start-up
Detector type programmed into panel
Detector type physically seen on loop.
Shows alarm or activated condition of point.
Detailed description of fault condition. i.e.: "No Response"
Polling, On, Off, Polling ID
Current Percentage of alarm or Degree Celsius
Current Percentage of Pre-alarm
O
C Highest reading since last reset.
Please refer to page 107 for information on Drift Compensation.
Detector sensitivity for day/night, alarm/pre-alarm. Please refer to
page 104 for explanation information on sensitivity settings.
Smoke Detector
ANALOG MENU – STATUS
DAY MODE
20 JULY 2002 14:44:37
L1D3 (Z990) > APARTMENT 1 BEDROOM
Poll Mode > FlashScan Mode
Programmed As > PHOTO-OPTICAL
Actual Device > PHOTO-OPTICAL
Device State > NORMAL
Device Status > NORMAL
LED Status > Polling
Detector Values: (Needs Cleaning)
Alarm = 0% Peak Alarm Value
Prealarm = 0% Day Alm Sensitivity
Compensation = 81% Day PreAlarm Sens
Night Alarm Sens
Night PreAlarm Sens
Device Scanned 255 Times .
PREV
NEXT TEST
A = 0
F = 0
I = 0
N = 0
= 10%
= 5
= 5
= 1
= 1
RESET Menu
35