Emergency Operation When Batteries Are Flat; Declaration Of Conformity; Restoring The Factory Setting; Technical Data - Honeywell HR92UK Installation Manual

Emergency operation when batteries are flat

1. Unlock the radiator controller. To do so, push the slide
at the radiator controller towards
2. Pull the radiator controller off the valve baseplate.
3. Operate the radiator valve by hand using the
adjustment dial on the baseplate.
+

Restoring the factory setting

1. Keep the button pressed for approximately
5 seconds until Parameter 1 flashes (left-hand digit).
2. Use the adjustment dial to select Parameter 12 (left-
hand digit) and Setting 1 (right-hand digit).
3. Press the button to restore the factory setting.
The binding is retained.
4. Use Exit to return to normal operation.

8. Technical data

Type
Protection class
Radio communication
Supply voltage
Connection to the radiator
Ambient temperature
Dimensions
Ambient conditions
Humidity
.
–
HR92UK
IP30
ISM (868.0 ... 870.0 MHz)
RX Class 2
Range: typically 30 m within
residential buildings
Battery type LR6, AA, AM3
Alkaline: 2 x 1.5 V
Lithium: 2 x 1.5 V
NiMH: 2 x 1.2 V
M30 x 1.5
0 ... 50 °C
96 x 54 x 60 mm
For living area, business and
commercial areas as well as
small businesses
10 ... 90 % rel. humidity
9. Disposal
The radiator controller has to be disposed of in
accordance with WEEE directive 2002/96/EC – Waste
Electrical and Electronic Equipment directive.
f Dispose of the packaging and product
f Do not dispose of the unit with the
f Do not burn the product.

10. Declaration of Conformity

Hereby Honeywell declares that this HR92UK is in
compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
11
in a corresponding recycling centre.
domestic refuse.