Assembly Instructions - Spirit 16007604850-1 Owner's Manual

ASSEMBLY INSTRUCTIONS

!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS.
PLEASE READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from unfolding
accidentally during shipping. If this strap is not removed properly, the treadmill could spring open
unexpectedly and cause injury if someone is standing near the treadmill when the strap is removed.
To ensure your personal safety during removal of the shipping strap, please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using the
treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This could
cause the treadmill's folding mechanism to spring open. If the end of the Velcro strap (that you
need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab it,
but do not tilt the treadmill up to gain access to the strap end.
Cut the banding straps with a short box cutter (razor knife); separate the carton from the one
underneath it by prying up on the staples (if applicable). Pull the carton over the treadmill parts and
locate the hardware pack. The hardware pack is separated into five sections; one section
containing tools and four sections labelled steps 1-4 which contain the hardware needed for
assembly of each step. The assembly steps below are numbered one through four and correspond
to the hardware in the numbered sections of the hardware pack. Remove only the hardware for the
step you are currently assembling to avoid confusion and mix-ups.
Then remove the treadmill from the carton and lay it on a level surface.
#131. Combination M5 Allen Wrench
& Phillips Head Screwdriver
#132. M6 Allen Wrench
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
ASSEMBLY TOOLS
#148. Phillips Head Screwdriver
8
Dyaco Canada Inc. 2016