Spirit 16007604850-1 Owner's Manual page 37

TREADBELT TRACKING ADJUSTMENT
The performance of your treadmill is dependent on the frame running on a reasonably level
surface. If the frame is not level, the front and back roller cannot run parallel, and constant belt
adjustment may be necessary. The treadmill is designed to keep the tread-belt reasonably centred
while in use. It is normal for some belts to drift near one side while the belt is running with no one
on it. After a few minutes of use, the tread-belt should have a tendency to center itself. If during
use, the belt continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING
A 6 mm Allen wrench is provided to adjust the rear roller.
Make tracking adjustments from the left side only. Set belt
speed at approximately 2 to 3 MPH. A small adjustment
can make a dramatic difference. Turn the bolt only a 1/4
turn and wait a few minutes for the belt to adjust itself.
Continue to make 1/4 turns until the belt stabilizes in the
center of the running deck. The belt may require periodic
tracking adjustment depending on use and walking/running
characteristics. Some users will affect tracking differently.
Expect to make adjustments as required to center the
tread-belt. Adjustments will become less of a maintenance
concern as the belt is used. Proper belt tracking is an
owner responsibility common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING / TENSION
ADJUSTMENTS IS NOT COVERED UNDER THE SPIRIT WARRANTY.
Customer Service 1-888-707-1880 37 Dyaco Canada Inc. 2016
Email: customerservice@dyaco.ca