Spirit 16007604850-1 Owner's Manual page 40

CALIBRATION PROCEDURE
1. Remove the safety key
2. Press and hold down the Start and Fast + buttons and replace the safety key. Continue to hold
the Start and Fast key until the window displays "Factory settings," then press the Enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs. Kilometers).
To do this, press the up or down key to show which you want, then press Enter. (The
maximum speed is displayed in the speed window, and the maximum elevation is displayed in
the incline window.)
4. Grade return – On (This allows the incline to return to zero when Stop is pressed.)
5. Press Start to begin calibration. The process is automatic; the speed will start up without
warning, so do not stand on the belt.
ADJUSTING THE SPEED SENSOR
If the calibration does not pass, you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 4 screws that hold it in place (you do not need
to remove them completely).
2. The speed sensor is located on the left side of the frame, right next to the front roller pulley (the
pulley will have a belt around it that also goes to the motor). The speed sensor is small and
black with a wire connected to it.
3. Make sure the sensor is as close as possible to the pulley without touching it. You will see a
magnet on the face of the pulley; make sure the sensor is aligned with the magnet. There is a
screw that holds the sensor in place that needs to be loosened to adjust the sensor.
Re-tighten the screw when finished.
ENGINEERING MODE MENU
The console has built-in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed, for example. To enter the Engineering Mode Menu, press and hold down the Start, Stop
and Enter keys. Keep holding the keys down for about 5 seconds, and the Message Center will
display Engineering Mode Menu. Press the Enter key to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. Display Test (Tests all the display functions)
3. Functions (Press Enter to access settings and Speed Up or Down keys arrow to scroll)
I. Display Mode (Turn on to have the console power down automatically after 30 minutes of
inactivity)
II. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause
indefinitely)
III. Maintenance (Allows you to reset the lube message time)
IV. Units (Sets the display to readout in English or Metric display measurements)
V. Beep (Turns off the speaker, so no beeping sound is heard)
4. Security (Allows the keypad to be locked to prevent unauthorized use)
5. Exit
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
40
Dyaco Canada Inc. 2016