Brave MVH1334C Owner/Operator And Safety Manual page 32

DO NOT mix tractor hydraulic oil with transmission fluid. Use one or the other.
4. Refill the hydraulic tank.
a. Reconnect inlet hose (2) to the pump.
b. Remove the hydraulic tank fill cap and
fill the tank with the recommended
type and quantity of oil. Replace the
cap.
5. Drain and refill the piston end of the
cylinder.
a. Hold the valve handle in the retract
position and pull the engine pull start
cord until the rod is fully retracted.
This step removes the old oil from the
piston end of the cylinder.
b. Reconnect return hose (1) to the oil
filter.
c. Extend the cylinder by holding the
valve handle forward and pulling on the
engine's pull start cord until the cylinder
is completely extended.
refills the piston end of the cylinder.
6. Start the engine and cycle the cylinder.
a. Replace the spark plug and spark plug
wire.
b. Start the
cylinder several times.
c. Retract the cylinder and shut off the
engine.
d. Recheck the hydraulic tank to make
sure oil is filled within one inch from the
top of the tank.
Brave
Important Notice
This step
engine and cycle the
30
800-350-8739