Operation - Brave MVH1334C Owner/Operator And Safety Manual

Operation

Do not attempt to operate the log splitter without fully understanding
all our
If any doubt or question arises about the correct or safe method of
performing anything found in this or other Brave' manuals, contact
your Brave' dealer or call the Sales and Service representatives at our
main headquarters. Proper care is your responsibility.
When operating the log splitter make sure you
are standing in the safe operating zone, as
shown in these pictures. You must stay in the
safe operating zone at all times when the
splitting wedge
extending or retracting). Never place any part
of your body in a position which would cause
an unsafe operating condition.
1. Position your log splitter on flat, dry ground.
Make sure
recommendations
section before using the log splitter.
2. Make sure both ends of the log you are
splitting are cut as square as possible.
This will prevent the log from sliding out of
position while under pressure.
should be 24 inches long or shorter.
Always wear protective gear, such as
safety goggles, tight-fitting gloves without
drawstrings or loose cuffs, steel-toed
Never attempt to split wood across the
grain. The log splitter was not designed
for cross-grain splitting.
damage the log splitter and may cause
personal injury.
800-350-8739
instructions,
is in motion
you read
from the
WARNING
Doing so will
WARNING
safety precautions,
(whether
all the
"Safety"
All logs
21
and/or warnings.
Brave