Table of Contents
Advertisement
c. Insert the two lower bolts through the
center mounting hole of the bracket and
the mounting strap. Loosely install the
lock- nuts.
d. Position the front edge of the bracket
approximately 2-1/2 inches from the rear
hitch coupler bolt hole, as shown.
e. Tighten all four locknuts using a torque
wrench and tighten to 25 foot pounds. Use
an alternating pattern to ensure they are
evenly tightened.
4. Install the tongue and front leg assembly
to the base unit using two 1/2-13 x 3-1/2
inch long hex head bolts and locknuts.
Tighten the nuts securely.
tongue/base unit off the pallet and lower
the front leg and lock it into position.
Make sure the rail assembly is standing on
a flat, level area. Have a helper steady the
rail to prevent it from tipping over. The rail
assembly
weighs
300 pounds and will cause bodily injury if
it falls on someone.
5. Carefully stand the rail assembly in an
upright, vertical position.
NOTE: If
also
BR021180 Log Cradle, assemble it at this
time. The log cradle uses the first and third
holes.
Brave
WARNING
approximately
installing
an
Roll the
optional
12
VH34-06b
800-350-8739
Advertisement
Table of Contents
