Table of Contents
Advertisement
f. Hold the control lever, extending the
splitting wedge, until the log is split or
the cylinder rod stops at its maximum
travel position.
(forward movement), at any point in the
splitting process, if you feel an unsafe
log splitting condition is occurring. As
the log is being split, DO NOT reach
forward and attempt to catch the split
wood — let it fall to the ground.
g. Once the wedge reaches its full for-
ward travel, pull back on the control
lever to the full retract position. The
ram of the cylinder will automatically
retract into the cylinder.
necessary to hold the control lever as
the cylinder retracts. Stop the wedge if
the log sticks (see caution below).
When the cylinder is fully retracted, the
control valve will automatically shift to
a neutral position.
h. DO NOT load another log or remove
the split pieces until the splitting
wedge has completely stopped and
the
control
returns to the neutral position.
Depending on the type of wood
being split, a log may not always
break into two pieces and fall to
the ground. If a log sticks to the wedge,
place the valve handle in the neutral
position (stop the wedge from retracting)
and carefully remove the log from the
wedge.
Allowing
attached to the wedge when it is fully
retracted could lead to possible injury
and/or damage to the log splitter.
800-350-8739
Stop the log splitter
handle
automatically
CAUTION
the
log
It is not
to
remain
27
Brave
Advertisement
Table of Contents
